Product Description:

The MLP100C-0120-FT-N0CN-NNNN is a primary mover from the MLP Synchronous Linear Motors series developed by Bosch Rexroth Indramat. This component replaces rotary motors and mechanical transmissions by generating thrust directly along an active track, allowing high-speed positioning in pick-and-place lines, portal axes, or processing tables on both short and extended travel paths. By eliminating backlash and belt wear, it supplies repeatable linear force for automated equipment that must accelerate loads quickly, stop precisely, and maintain consistent positioning through repeated cycles.

At its continuous operating point, the mover produces a nominal thrust of 2310 N and keeps the carriage moving at 190 m/min while carrying a phase load of 15.0 A. The coil set is built to motor size 100 and uses a thermo-encapsulation method that helps stabilize the winding package during temperature changes and repeated thermal cycling. Power exits the front face through a 1.5 mm² lead, and the winding has 4.0 ohms of resistance with an inductance of 19.436 mH. Liquid cooling circulates through 0.212 L of internal channel volume, and a flow of 2.3 L/min sustains convection with only 0.8 bar pressure drop. Short bursts can raise thrust to 7150 N and draw up to 84.9 A, yet no encoder is installed, so position data must come from an external measurement system connected to the drive.

Under overload, the coil rejects up to 1600 W of heat that the coolant loop must remove to prevent derating during heavy-duty motion. When commanded to maximum force, traversal speed is limited to 120 m/min. Passive magnetic attraction toward the secondary reaches 10400 N, so the axis requires stiff guide rails and secure structural support. The housing carries an IP65 rating, sealing the stator cavity against dust and water jets while the liquid circuit passes through O-ring ports, which supports use near coolant splash and airborne debris.