Product Description:

The MLP100B-0250-FT-N0CN-NNNN is a primary section in the MLP Synchronous Linear Motors series manufactured by Bosch Rexroth Indramat. Designed for direct-drive transport and positioning tasks, this linear motor segment applies force directly along the travel path instead of relying on belts, screws, or gear trains. That arrangement helps reduce mechanical wear points and supports fast, accurate motion in assembly cells, packaging lines, and machining centers. Its integrated water channels help control coil temperature, while thermal encapsulation helps keep the winding geometry stable during rapid duty cycles.

At peak load, the mover can deliver a thrust of 5600 N when the windings draw the maximum current of 142.6 A. During continuous operation, the rated operating point requires 24.1 A, where the motor supplies a continuous nominal force of 1785 N without overheating because of water cooling. The motor reaches a nominal speed of 350 m/min under rated force, while the maximum speed at full thrust is limited to 250 m/min to keep the magnetic system within acceptable temperature limits. This operating range suits axes that need short move times, repeatable acceleration, and controlled thermal behavior during frequent cycles.

With thermal encapsulation in place, the mover weighs 23.3 kg. It measures 535 mm in length, 168 mm in width, and 73.9 mm in height, which allows installation inside compact linear tracks while still providing a substantial active section. The housing is made of titanium-alloyed stainless steel, which resists corrosion from process fluids and tolerates the internal water-cooling circuit. Coolant channels run close to the coil pack so heat is removed near the copper conductors, and the encapsulation helps limit vibration at the magnetic gap during repetitive motion.