Product Description:

The MKE116D-027-NG0-KN is an AC servo motor produced by Bosch Rexroth Indramat and assigned to the MKE Synchronous Motors series. In automated lines, it delivers commanded rotary motion so axes can achieve repeatable position, velocity, and torque profiles for packaging, cutting, or indexing equipment. The unit is intended to pair with Rexroth drive controllers and mechanical gear stages for closed-loop motion control tasks. This arrangement supports synchronized motion where the controller must correct for changing loads without losing positioning accuracy.

Electrical and mounting interfaces are arranged on the Top, allowing cable runs to exit vertically and stay clear of adjacent hardware. Power and feedback conductors terminate inside a cast-aluminum terminal box, so individual cores can be landed on screw blocks instead of permanent connectors. For installations that rely on braking torque from the drive, the motor is supplied without a holding brake, so no brake coil wiring is required. A plain shaft accepts keyed or clamped couplings with minimal runout, and the machined frontal centering hole supports accurate alignment against the driven element during assembly. This layout keeps the main connection points together and can simplify cable routing near adjacent axes.

A fitted shaft seal helps block oil mist and fine dust from migrating along the journal into the bearing set. The threaded end uses a DIN 332-compliant "DS" thread, so a standard puller or transport eye can be attached when the rotor must be secured for service. Internally, the stator uses the 027 winding, which lets compatible drive data sets apply the proper current limits and temperature models. The motor is designated as a servo motor for potentially explosive areas, indicating that the enclosure, terminals, and surface temperatures are prepared for zones where ignitable gases may be present. This rating supports controlled motion in locations where hazardous atmospheres can occur during normal operation.