Product Description:

The MKE096B-047-NP0-KN is a servo motor built by Bosch Rexroth Indramat and sold within the MKE Synchronous Motors series. Classified for use in hazardous zones, it is intended for closed-loop position and velocity control on machines that operate where flammable gases or dust may be present. When paired with a compatible Rexroth drive, the motor delivers precise rotary motion for chemical mixers, paint lines, and grain-handling equipment while supporting safe operation in these environments. This arrangement supports repeatable speed regulation and controlled positioning during starting, running, and stopping cycles. It is suited for process equipment that requires accurate feedback-based motion control inside regulated production areas.

Cabling enters the housing from the top, a layout that keeps conductors clear of floor-mounted obstructions and allows short, direct routes to ceiling-mounted conduit. The top-entry arrangement can also reduce cable bends near the motor body when wiring is routed upward through a protected conduit path. Power and feedback cores terminate inside a sealed terminal box, so field wiring can be completed without exposing the stator interior. The stator uses the 047 winding, which identifies the coil resistance and inductance selected for balanced current draw and thermal loading with compatible Rexroth inverters. Mechanical power reaches the load through a hardened shaft with a keyway, and the DIN 6885 keyway standard keeps the key dimensions consistent for common pulleys, gears, and couplings.

The motor is supplied without a holding brake, so vertical axes must rely on external braking or drive torque to maintain position during power loss. A fitted shaft seal blocks dust and oil ingress at the coupling interface, which helps preserve bearing grease life in contaminated atmospheres. The sealed output area also helps the motor remain suitable for dusty or oily processing spaces where exposed coupling surfaces can collect contamination. Its construction is intended for Zone-classified installations, with measures that limit surface temperature and reduce ignition risk in sensitive areas.