MKD112C-058-GG2-BN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911275472
The Bosch Rexroth Indramat MKD112C-058-GG2-BN is a servo motor from the MKD Synchronous Motors series. It provides a continuous torque at standstill of 38.0 Nm and features a plain shaft with shaft seal and a 130 mm centering diameter. This motor is equipped with resolver feedback for position detection, carries an IP65 protection category, and uses insulation class F.
Internal Product Review
The MKD112C-058-GG2-BN is a Bosch Rexroth Indramat servo motor designed for consistent industrial motion service. IP65 protection and resolver feedback support dependable operation and stable control performance in machine applications. Continuous standstill torque of 38.0 Nm gives this model strong axis authority, making it a very capable choice for demanding servo duty.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MKD112C-058-GG2-BN belongs to the MKD Synchronous Motors series produced by Bosch Rexroth Indramat. It is a servo motor intended for closed-loop drive axes, where it converts drive commands into precise rotary motion for packaging lines, gantries, and material-handling stations. In normal operation, the motor works with a matching controller to regulate torque, speed, and position during repeated starts, stops, and load changes. This makes it suitable for machines that need accurate indexing, synchronized transfer, or controlled speed changes over repeated cycles.
The motor delivers a continuous standstill torque of 38.0 Nm, allowing it to hold load inertia without additional gearing in many servo applications. A flange of 192 mm mounts the housing to machine frames, and the centering diameter is 130 mm to keep the drive train aligned during installation. Feedback is supplied through Resolver feedback (RSF), which reports rotor position for commutation and closed-loop control rather than absolute position after power-up. The windings use insulation class F, which permits internal winding temperatures up to 155 °C. The motor is built in size 112 with length C, uses a plain shaft, and includes a shaft seal to help limit contaminant entry and lubricant loss at the drive end.
The housing has an IP65 enclosure that helps protect the motor against dust and water jets in industrial settings. Operation is permitted between 0–40 °C, and system accuracy reaches ±8 angular minutes for applications that require repeatable positioning. Cabling exits on Side B, which can simplify routing when the machine layout favors that connection direction. The motor uses winding code 058 for electrical values matched to compatible Indramat drive modules, and an output connector carries both power and feedback conductors. Because the position signal is relative, the axis normally performs a homing move at startup before full position references are used.
