Product Description:

The MKD112C-024-GP2-AN is a servo motor from Bosch Rexroth Indramat's MKD Synchronous Motors series. It converts electrical power into controlled rotational movement for axes in automated assembly cells, material-handling gantries, and similar industrial equipment. The unit works with a matched drive controller in a closed feedback loop so velocity, torque, and indexing commands can be carried out with repeatable accuracy. This arrangement suits positioning tasks that require stable response during acceleration, dwell, and reversal.

The motor uses winding code 024 with a size 112 stator and a length C housing, giving a continuous stall torque of 38.0 Nm for sustained load holding. A centering diameter of 130 mm aligns the motor to the machine interface, while the 192 mm square flange provides the mounting face. Power and feedback conductors are routed through an output connector on the A-side, which helps keep cable routing predictable around the machine. A keyed shaft transfers torque to couplings, and an integral shaft seal helps keep lubricant from migrating along the shaft. Sealed bearings and gasketed joints add protection against dust and common shop-floor contaminants inside the housing.

Feedback is provided by resolver feedback, which sends rotor position signals to the drive and supports closed-loop motor control. When combined with the drive, the feedback system provides accuracy of ±8 angular minutes for motion profiles that do not require a separate encoder. The windings use insulation class F, which allows winding temperatures up to 155 °C, and the housing is sealed to IP65 to resist dust and water jets. Safe ambient operation is specified at 0–40 °C, allowing the motor to run within its stated temperature range in normal industrial environments. Because the resolver monitors rotor position directly, the motor supports dependable speed and position regulation without an added external feedback device in many applications.