MKD112B-024-GP2-BN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911317606
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MKD112B-024-GP2-BN is a servo motor from the MKD Synchronous Motors series, featuring a continuous torque at standstill of 28.0 Nm and resolver feedback for position detection. The motor comes with a flange size of 192 mm, centering diameter of 130 mm, and an IP65 protection category. It is built with a shaft with keyway and insulation class F, and supports operation in ambient temperatures from 0 to 40 degrees Celsius.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MKD112B-024-GP2-BN is a three-phase servo motor produced by Bosch Rexroth Indramat for the MKD synchronous motors series. Intended for use with digital drive controllers, it converts controlled current into repeatable torque and speed for indexing tables, packaging axes, and CNC feed drives in industrial automation lines. This arrangement allows the motor and drive to work together in closed-loop motion systems where steady speed control and accurate positioning are required. It is commonly used on axes that must start, stop, and reverse quickly without losing commanded position during repeated production cycles.
At standstill, the unit supplies a continuous torque of 28.0 Nm, allowing loads to remain controlled during machining or dwell periods. The centering shoulder measures 130 mm, and the flange size of 192 mm provides a standardized mounting interface for accurate mechanical alignment. These mounting dimensions help the motor seat securely against the machine interface and keep shaft alignment consistent across repeated installations. The enclosure is rated IP65, which helps block dust and resists low-pressure water spray in typical industrial areas. Resolver feedback supports commutation, and overall system error is limited to ±8 angular minutes for applications that require repeatable closed-loop positioning.
Power and feedback leads exit on Side B through a dedicated output connector, which can simplify cable routing when several axes are installed in the same machine section. This connector arrangement keeps power and signal wiring grouped at one end of the housing and can reduce cable crossings in compact layouts. The windings use F-class insulation and are intended for ambient temperatures of 0–40 °C, supporting continuous operation while maintaining dielectric strength. A keyed steel shaft transmits torque to the driven load, and an integral shaft seal helps separate internal lubricant from external contaminants. The keyed shaft also supports positive torque transfer to couplings, pulleys, or gear inputs where slip cannot be tolerated.
