Product Description:

The MKD112A-024-KP0-BN is a servo motor produced by Bosch Rexroth Indramat within the MKD Synchronous Motors series. It serves as an electromechanical actuator in automated equipment. The motor converts commanded drive current into regulated rotary motion for positioning and velocity control on conveyors, tool spindles, and gantry axes. Its synchronous design supports responsive speed changes and stable torque output when used with a compatible drive controller. That makes it suitable for coordinated motion tasks that require repeatable rotary output under changing load conditions during normal production cycles.

At standstill, the motor supplies a continuous torque of 15.0 Nm, providing the holding force required for static loads during indexing cycles. A centering diameter of 130 mm aligns the housing to machine plates, and the 192 mm flange size matches common mounting adapters. The enclosure carries an IP65 rating, so the interior is sealed against dust and water jets typically encountered on factory floors. Position feedback is delivered by integrated resolver feedback, generating sine-cosine signals that the drive uses for interpolation and commutation. That feedback arrangement helps maintain accurate rotor alignment during acceleration and low-speed operation.

Cabling exits on Side B, simplifying routing when power and feedback leads are dressed toward the rear of the machine frame. The output uses a shaft with keyway and includes a shaft seal that helps block coolant spray from the bearing set. Closed-loop control benefits from a system precision of ±8 angular minutes and absolute position detection beyond 4,096 revolutions, which supports homing-free startup routines. Continuous operation is permitted within an ambient range of 0–40 °C, and Class F insulation provides thermal margin when winding code 024 is driven at high RMS currents. This A-length, size-112 motor is supplied without a holding brake, which keeps reflected inertia low for rapid acceleration profiles.