MDD112C-N-020-N2M-130GB1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911283588
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
11 Seconds
The Bosch Rexroth Indramat MDD112C-N-020-N2M-130GB1 is a motor for digital drive controllers that belongs to the MDD Synchronous Motors series. It features a continuous torque at standstill of 28 Nm, a nominal speed of 2000 min-1, and an integrated multiturn absolute encoder. The motor is equipped with a plain shaft, connector type connection, and a blocking brake with a holding torque of 14 Nm.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD112C-N-020-N2M-130GB1 synchronous servo motor is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Built for use with digital drive controllers, this three-phase permanent-magnet unit supplies commanded motion to conveyors, gantries, and material-handling axes. Its purpose is to convert regulated electrical power into precise mechanical torque and speed so automated stations can maintain repeatable positioning and acceleration profiles. This makes the motor suitable for applications that require stable closed-loop motion and predictable response during changing load conditions.
Continuous stall capability reaches 28.0 Nm, allowing the motor to hold or slowly move loads without overheating when the shaft is locked or turning very slowly. During rated operation, the rotor can reach 2000 rpm, which gives the drive a practical operating range for general servo applications. A blocking brake supplies up to 14.0 Nm of static torque so suspended loads remain secure whenever drive power is removed. Mechanical centering is achieved with a 130 mm pilot diameter, and all power and feedback connectors exit on side B of the housing to simplify cable routing when the opposite face is obstructed. The rotor is balanced to a standard quality grade to help reduce vibration during dynamic motion.
Position data is returned through digital servo feedback (DSF), and an integrated multiturn absolute encoder stores full revolutions so the control system can retain position information after shutdowns. The output configuration uses a shaft seal and a plain shaft, which supports clamp-style couplings while helping protect internal components from coolant spray. Overall stack length follows motor length code C, providing additional active material without changing the 112 mm frame size. Standard housing construction supports consistent heat flow through the motor body during continuous operation. This combination of feedback, shaft arrangement, and frame geometry suits axes that need accurate positioning without an external position sensor.
Frequently Asked Questions about MDD112C-N-020-N2M-130GB1:
Q: What type of encoder does the MDD112C-N-020-N2M-130GB1 motor have?
A: The MDD112C-N-020-N2M-130GB1 includes a multiturn absolute encoder for position measurement.
Q: What is the continuous torque at standstill for the MDD112C-N-020-N2M-130GB1?
A: This motor can provide a continuous torque of 28.0 Nm at standstill.
Q: What is the holding brake torque on the MDD112C-N-020-N2M-130GB1 motor?
A: The holding brake on this model provides a torque of 14.0 Nm.
Q: What type of shaft end does the MDD112C-N-020-N2M-130GB1 feature?
A: The shaft end on this motor is a standard type without a side B shaft end.
Q: What type of motor feedback does the MDD112C-N-020-N2M-130GB1 use?
A: Digital servo feedback (DSF) is integrated into this model for motor feedback.
