Product Description:

The MDD093D-N-060-N2M-130PA2 is a synchronous servo motor produced by Bosch Rexroth Indramat for use with digital drive controllers in industrial motion axes. It belongs to the MDD Synchronous Motors series, fits the 093 frame size, and uses a standard housing that can mount directly into compact machinery cells. By converting electrical commands from the drive into precise rotary motion, the unit serves as an actuator for packaging lines, material-handling gantries, and automated tooling that require fast acceleration and repeatable speed. It is also suitable for feed axes and transfer modules where frequent starts, stops, and direction changes are part of normal operation.

At the mounting interface, a centering diameter of 130 mm aligns the flange with the machine frame for accurate seating. During continuous standstill, the motor can deliver 24.0 Nm of torque, providing solid holding force without excessive thermal stress. Under rated conditions, the rotor reaches a nominal speed of 6000 rpm, allowing high throughput when paired with suitable gearing. A permanent-magnet holding brake provides 22 Nm of retention to help keep the axis in place when power is removed. Feedback is supplied through digital servo feedback, allowing the controller to monitor rotor position and speed in a closed loop during acceleration, deceleration, and load changes.

All power and signal conductors exit on side A through a sealed connector, which helps simplify cable routing where rear clearance is limited. The output uses a keyway shaft so torque can be transferred securely to couplings, pulleys, or gear units. The shaft is fitted with a shaft seal, which helps limit the movement of contaminants or lubricant toward internal bearing areas. A standard single-ended shaft leaves no extension on side B, so the motor can be mounted close to adjacent machine elements. The D motor length adds lamination depth for higher peak torque while keeping the same 093 frame outline.