Product Description:

The MDD093D-N-060-N2M-130GL1 is a three-phase synchronous motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It serves as the rotary actuator in digitally controlled servo axes, translating the commanded current from an inverter into torque and speed for automated gantries, feeders, and assembly modules. The model works with high-resolution encoder feedback, letting the drive command precise motion profiles while the motor’s permanent-magnet rotor yields rapid dynamic response required in industrial automation.

In continuous operation the motor delivers a standstill torque of 24.0 Nm, giving drive designers a wide margin for holding or low-speed duties without resorting to oversizing. Its peak working envelope extends to a nominal speed of 6000 min⁻¹, so high cycle processes can reach target velocities with minimal delay. The frame corresponds to motor size 093, and the stator pack specified by length code D increases copper volume for higher power density within that footprint. A centering diameter of 130 mm simplifies concentric mounting on gearboxes or mechanical fixtures, while the standard balancing grade limits vibration when the shaft is coupled directly to precision loads. The housing design is marked as standard and uses a connector interface for electrical terminations.

For braking and positional security, an integrated blocking brake supplies 11 Nm of static torque and is released electrically during motion. Feedback to the controller relies on digital servo feedback, augmented by an integrated multiturn absolute encoder to maintain position data across power cycles. Mechanical transmission is handled by a Plain shaft protected by a shaft seal, and the power and signal connectors are oriented on the motor’s left side, referred to as the Left connection direction. Standard housing and balancing choices keep the motor compatible with the wider MDD family, while the absence of a secondary shaft end reduces overall length.