Product Description:

The MDD093D-N-060-N2M-130GL0 is a synchronous servomotor manufactured by Bosch Rexroth Indramat as part of the MDD Synchronous Motors series. It is intended for use with digital drive controllers and produces controlled rotary motion in automated production equipment, pick-and-place stations, and handling axes that require fast and repeatable positioning. When paired with a compatible Indramat drive, the motor converts three-phase electrical energy into commanded torque and speed under closed-loop control. This operating role makes it suitable for machinery that must accelerate quickly, stop accurately, and return to the same position over many repeated cycles.

The motor uses size 093 frame dimensions and a D length code, and the centering flange measures 130 mm to fit precision-bored machine plates. Standard balancing helps keep residual vibration low, while the standard housing provides the cooling surface needed for normal operation. A continuous standstill torque of 24.0 Nm allows the axis to hold load during indexing, and the motor reaches a nominal speed of 6000 rpm for high-throughput motion. Position information is supplied by an integrated multi-turn absolute encoder, which lets the controller retain shaft position information after a stop or power interruption. Power, encoder, and protective earth conductors are grouped in a single connector on the left side of the stator, and a shaft seal helps block splash water and oil at the front bearing area.

Dynamic response is supported by digital servo feedback, which sends incremental and absolute position data to the control loop for precise correction during operation. The rotor uses a plain shaft without a keyway, and only the front shaft end is provided, leaving the rear face clear for adjoining machine elements. Because the motor is supplied without a blocking brake, holding force during power-off conditions must come from the drive system or from an external mechanical device. This arrangement is often used where the axis is controlled electrically during operation and separate holding hardware is selected according to the machine layout.