Product Description:

The MDD093D-N-060-N2M-110GR1 is a synchronous servo motor built by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts commanded current into precise rotary motion for positioning axes, gantries, or processing spindles in automated equipment. Its plain shaft and standard housing allow direct coupling to gearheads or load-side components. An internal blocking brake also helps hold the load when power is removed.

This unit can maintain a continuous standstill torque of 24.0 Nm, so it supports static loads without overheating while the axis remains stationary. During motion, it reaches a nominal speed of 6000 rpm, which supports fast travel and short cycle times in high-response applications. The blocking brake provides a holding torque of 11 Nm, helping prevent back-driving on vertical axes after the controller commands the brake to engage. A centering pilot of 110 mm keeps the motor aligned with adjoining machine faces to reduce vibration and support accurate installation. Closed-loop regulation relies on digital servo feedback, allowing the controller to compare commanded and actual positions during operation for stable speed and position control.

Cabling is simplified because all power and signal terminations are located on the right side of the housing, and the motor uses a single keyed connector instead of individually wired terminals. A shaft seal is fitted at the output end to help keep dust and coolant away from the bearing area during operation. Position data is supplied by an integrated multiturn absolute encoder, so the drive can retain revolution information through power cycles and restore position data without a reference run. Standard dynamic balancing keeps residual rotor forces low during rotation. The plain output shaft also matches a configuration without a second shaft end, which supports direct mechanical integration in compact drive assemblies.