Product Description:

The MDD093D-N-060-N2M-110GB2 is a synchronous servo motor within the MDD Synchronous Motors series. It is used with digital drive controllers and converts commanded current into regulated rotation for positioning, indexing, and speed-controlled axes in packaging lines, assembly cells, and material-handling equipment. The size 093 frame and D length give the motor a compact form for high-speed duty where closed-loop accuracy is required. Its permanent-magnet design also supports fast response to changing drive commands during repeated motion cycles.

The motor delivers 24.0 Nm of continuous standstill torque, which helps an axis support reflected inertia without auxiliary gearing. At a nominal speed of 6000 rpm, it suits applications that require rapid point-to-point movement and short cycle times. A spring-applied brake provides 22 Nm of holding torque, and the motor has a 110 mm centering diameter for accurate mounting. All power and feedback leads exit on side B, which can simplify cable routing in machines that use rear-facing cable runs. Standard dynamic balancing, a standard housing, and a plain shaft end on the drive side keep the mechanical layout straightforward.

The unit uses an integrated multi-turn absolute encoder to track position over multiple revolutions, so the drive can retain position information across a wide motion range. Communication with the drive is handled through Digital servo feedback (DSF), which supports precise velocity and torque control. The motor has a plain shaft with a shaft seal, and no secondary shaft is provided on the non-drive side. Power and signal lines terminate in a keyed connector, which keeps the electrical interface compact and secure. This arrangement helps maintain orderly cable connections around the motor while leaving the non-drive end clear.