Product Description:

The MDD093D-N-060-N2L-130PA2 is a synchronous servo motor produced by Bosch Rexroth Indramat and supplied within the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts commanded current from the inverter into controlled rotary motion for positioning and speed-control tasks in industrial automation. In automated equipment, this supports controlled starts, stops, and speed changes on feed axes, indexing mechanisms, and similar motion applications. The unit is suited for machines that need high speed and repeatable torque, and it uses the standard housing pattern for this motor family.

This model delivers a continuous standstill torque of 24.0 Nm, allowing the drive to maintain load without active cooling. When energized, it can reach a nominal speed of 6000 rpm, so axis cycles can be completed quickly while remaining within thermal limits. The centering pilot measures 130 mm, which aligns the flange with the machine mounting face and helps maintain accurate positioning. Power, feedback, and brake conductors exit on Side A, which can simplify cable routing in left-hand layouts and reduce cable crossings near adjacent machine parts. The integrated blocking brake provides 22 Nm of holding torque to keep vertical or suspended loads stationary when the inverter is de-energized.

Dynamic loop closure is supported by digital servo feedback from an internal encoder, and this signal is used by the drive controller for precise rotor position monitoring during motion. The encoder channel helps maintain stable closed-loop response during acceleration, reversal, and position holding. The stator uses the D length code, which gives the motor a longer active stack than shorter versions in the same series. This assembly fits the 093 frame size housing, and the shaft includes a keyway with a shaft seal to help block oil or dust along the journal. Electrical termination uses a rear connector, and the motor has a standard single-shaft-end configuration.