Product Description:

The MDD093D-N-060-N2L-130PA1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat as part of the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts regulated current from the drive into precise rotary motion for coordinated axes in packaging equipment, gantry robots, and machine-tool applications. Its synchronous design supports fast response to changing commands, which helps the drive maintain accurate speed and position during frequent starts, stops, and reversals. The motor is suited for closed-loop motion tasks that require repeatable performance over short, rapid cycles.

This motor sustains a continuous standstill torque of 24.0 Nm, allowing it to hold static loads without overheating when the axis is stopped. During motion, its rotor can reach a nominal speed of 6000 rpm, which supports high cycle rates where short positioning times are important. A blocking brake integrated on the non-drive end supplies 11 Nm of mechanical holding force to secure vertical or suspended loads after power is removed. Position and velocity are monitored through digital servo feedback (DSF), providing high-resolution data to the drive for closed-loop control. The flange has a centering diameter of 130 mm, which helps align the motor accurately with adjoining machine plates, and the output shaft uses a keyway so couplings can transmit torque without slipping.

Cabling enters on Side A, keeping the power and feedback conductors on one face of the motor for simpler routing in compact enclosures. The hybrid power and feedback plug uses a connector for direct cable attachment and locks with a quarter-turn collar. A factory-installed shaft seal helps prevent oil or coolant from migrating along the shaft into the bearing cavity. The extended motor length increases active stack depth while keeping the same basic mounting outline, which supports higher torque output within the housing size.