Product Description:

The MDD093D-N-060-N2L-110PB0 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts commanded current into proportional torque for axes that require fast positioning and cyclic speed reversal in industrial automation. Its design integrates electronic commutation and a permanent-magnet rotor, allowing the paired drive to regulate motion through the internal digital servo feedback sensor. This makes the motor suitable for packaging equipment, transfer systems, and other servo axes that need repeatable motion under changing load conditions.

At standstill, the motor can deliver a continuous torque of 24.0 Nm, so the axis can hold static loads while the windings remain within thermal limits. During motion, it reaches a nominal speed of 6000 rpm, providing high surface velocity for compact spindles or transfer mechanisms. A standard dynamic balancing grade minimizes vibration, and the centering pilot measures 110 mm to align the frame to the machine flange. Power and feedback conductors exit on side B, and the single-plug connector interface supports quick installation while keeping cable routing concentrated at the rear of the housing.

The motor uses frame size 093 with stack length code D, which gives it a longer active section within this housing diameter. Contaminant entry is limited by a shaft seal at the output end, and the solid shaft uses a keyway to transmit torque to couplings or pulleys. The standard shaft-end arrangement omits a second shaft extension on side B. The motor is supplied without a blocking brake, so vertical or suspended loads require an external holding device when power is removed, and the sealed output end helps protect internal bearing areas from dirt and light splash.