Product Description:

The MDD093D-N-060-N2L-110PA0 is a synchronous servo motor built by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It works with compatible digital drive controllers to provide closed-loop torque and speed control in handling units, packaging axes, and machine-tool spindles. The motor is intended for dynamic industrial axes that require repeatable motion during frequent starts, stops, and speed changes. Its housing format follows the general outline used across the series, which helps it fit into existing machine spaces without unusual mounting changes.

The motor reaches a nominal speed of 6000 rpm, which supports rapid positioning when the drive sends high-frequency commands. At zero speed, it can deliver 24.0 Nm of continuous torque, which helps maintain force at standstill during controlled motion. This speed range is useful for direct-coupled axes that need short cycle times without relying on aggressive gear reduction. The flange uses a 110 mm pilot diameter to keep the motor centered during installation. Power and feedback connections are oriented on Side A, which helps when cable space is limited behind the machine. Position and velocity signals are returned through digital servo feedback, allowing the controller to maintain closed-loop operation as the load changes.

The output shaft includes a keyway so pulleys or couplings can be locked in place during dynamic operation. A factory-installed shaft seal helps protect the bearing area from coolant splash and light contamination near the drive end. Electrical connections are made through a locked connector, which keeps wiring compact and avoids loose lead routing at the motor body. The motor is supplied without a blocking brake, so any holding force required during power-off conditions must come from the drive or an external clamp. For vertical axes or suspended loads, the machine must provide a separate holding method when power is removed.