Product Description:

The MDD093D-N-060-N2L-110GB2 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Intended for use with digital drive controllers, the unit delivers regulated rotary motion for indexing tables, gantry axes, and other positioning elements used in automated production equipment. It is suited for coordinated motion tasks where torque and position must follow controller commands through repeated start, stop, and dwell cycles. A standard aluminum housing conducts heat to ambient air and supports panel or machine-frame mounting without external cooling components.

This motor supplies 24.0 Nm of continuous torque at standstill, allowing stable force output when the shaft must hold or slowly advance a load. A maximum speed of 6000 rpm extends its use to high-speed pick-and-place or spindle-related tasks where short cycle times matter. To secure the load during power-off, a blocking brake is integrated; it clamps the shaft with 22 Nm of holding brake torque. Position feedback is handled by digital servo feedback (DSF), which supplies high-resolution angle data to the controller for tight closed-loop regulation. Machine wiring enters on side B, and all power and signal conductors terminate through a molded connector that helps keep cable routing compact at the rear of the motor.

The centering pilot is 110 mm in diameter to align the flange precisely on gearboxes or adapter plates, and the rotor uses standard balancing to keep vibration low across the speed range. The motor has size 093 with length code D, which gives it a longer stator stack for higher continuous output in this frame. It has a plain shaft and no rear shaft extension, which can simplify coupling where rear shaft access is not needed. A shaft seal is included, so lubricant and airborne contaminants are less likely to migrate toward the bearing and feedback area during operation in oil mist or coolant-laden environments.