Product Description:

The MDD093D-N-040-N2M-130PR0 is a synchronous servo motor developed by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Serving as a motor for digital drive controllers, it converts electrical commands into controlled rotational motion for positioning axes, packaging stations, and pick-and-place modules throughout industrial automation. It is intended for applications that require accurate speed regulation and repeatable positioning during frequent start-stop motion.

Its continuous torque at standstill reaches 24.0 Nm, allowing the drive to hold a load without overheating during static clamping or vertical lifting. A nominal speed of 4000 rpm supports high-throughput lines that require short cycle times while keeping velocity control inside the servo loop. The motor uses a centering diameter of 130 mm for accurate alignment with machine flanges, and the power and feedback conductors exit on the right side to simplify cable routing in tightly packed assemblies. The output shaft uses a keyway, which provides positive torque transfer to pulleys or couplings and helps prevent slip under changing loads.

The integrated multiturn absolute encoder works with the digital servo feedback interface to report position over multiple revolutions, allowing operation without a homing routine after power loss. Because the motor is supplied without a blocking brake, any static holding function must come from drive torque or an external mechanical lock. A shaft seal protects the bearing area from escaping lubricant and airborne contamination. The molded connector supports straightforward cable attachment, and the single-ended shaft layout leaves the opposite end unobstructed. In size 093 with length code D, the rotor geometry is suited to medium-mass loads while preserving responsive servo behavior.