Product Description:

The MDD093D-N-040-N2M-130PL0 is a synchronous servo motor from Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is intended for use with digital drive controllers on automated machinery that requires precise torque output and responsive speed control. This motor suits indexing axes, transfer systems, and similar equipment where stable servo regulation is important.

A 130 mm centering pilot supports rigid flange alignment and helps keep the motor concentric with the driven mechanism. The unit delivers 24.0 Nm of continuous stall torque, allowing an axis to hold load at standstill without excessive heating under rated conditions. A nominal speed of 4000 min⁻¹ supports fast traverse motion, and the power and feedback leads exit on the left side through a sealed connector for clean cable routing.

An integrated multiturn absolute encoder supplies full shaft position after power cycles, which helps the drive recover machine position without a homing move. Higher-level controllers receive signals through digital servo feedback (DSF), supporting accurate closed-loop regulation during changing loads and speeds. Torque is transmitted through a keyway shaft, and the output end is built with a shaft seal to resist contaminant ingress in demanding industrial environments.

Wake Industrial stocks this motor and can arrange same-day shipping for urgent orders when downtime makes replacement timing especially important during unplanned production stoppages. Quotations remain valid for 30 days, which helps purchasing teams manage approvals efficiently without rushing a decision. The chat tool available on the website can be used for general questions about type codes or fault codes before ordering.