Product Description:

The MDD093D-N-040-N2M-130GR0 is a synchronous servo motor in the MDD Synchronous Motors series. Designed for use with digital drive controllers, it provides closed-loop rotary motion for positioning, indexing, and speed-controlled operation on automated equipment. Its servo construction supports repeatable starts, stops, and directional changes on production and material-handling axes. This type of motor is commonly used where the drive must coordinate torque, speed, and position in one compact axis package. The motor format also suits packaging machines, transfer systems, and other equipment that depend on consistent servo response through repeated cycles.

A centering shoulder of 130 mm supports accurate mounting in the machine frame, and the housing uses a right-side connection layout for organized cable routing. The motor can deliver a continuous standstill torque of 24.0 Nm, which helps the axis resist static load at zero speed. During motion, it reaches a nominal speed of 4000 rpm for applications that need fast response and high cycle rates. Position information is returned through Digital servo feedback (DSF) from an integrated multi-turn absolute encoder, so the controller retains position data after power is removed. A sealed connector carries both power and feedback signals through one interface, which reduces separate cable entries on the motor housing.

The rotor uses standard balancing to reduce residual vibration at rated speed. The motor has length code D, which indicates a longer housing within this frame size and provides a larger active stack. Mechanical output is transmitted through a plain shaft, which is intended for coupling arrangements that do not require a key. A factory-installed shaft seal helps limit lubricant escape and helps keep dust away from the bearing area. The sealed shaft end is suited to installations where airborne contamination or light splash must be kept away from internal bearing surfaces. The motor is supplied without a blocking brake, so power-off holding must be provided by the machine or the drive.