Product Description:

The MDD093D-N-040-N2L-130GR0 is an AC servomotor built by Bosch Rexroth Indramat for motion axes that use digital drive controllers in the MDD Synchronous Motors series. This unit has size 093 with length code D, making it suitable for rapid positioning and speed control on packaging lines, handling gantries, and similar automated stations. Its plain shaft and integrated shaft seal allow direct coupling to gearboxes or pulley sets while helping keep lubricants and dust away from the bearing area. The motor is intended for closed-loop axes where repeatable acceleration and stable speed control are needed throughout production.

The motor can supply 24.0 Nm of continuous torque at standstill, so it can hold an energized axis steady when motion stops between cycles. Its rated mechanical speed reaches 4000 rpm, which lets the same frame handle fast traverse moves as well as slower indexing tasks through the connected drive. A centering pilot of 130 mm aligns the flange with the machine interface to reduce radial misalignment and support smooth running. Position data returns to the controller through digital servo feedback, allowing the drive to monitor rotor position directly and respond quickly to changes in load, inertia, or friction.

Cables exit on the Right through a keyed power and signal Connector, which helps cable routing when several axes are mounted side by side. Rotor balancing is Standard, making the motor appropriate for general-purpose transfer and handling equipment. The drive end uses a Plain shaft, so clamping hubs or couplings can be installed without a keyway. The motor is supplied without a blocking brake, so any holding function during power-off conditions must come from the machine or external hardware. This arrangement suits installations that use external holding devices or rely on drive torque during controlled stops.