Product Description:

The MDD093D-N-040-N2L-110GR2 is an AC permanent-magnet servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed for digital drive controllers, it converts commanded current into controlled torque and speed for indexers, packaging axes, and material-handling gantries. An internal position transducer supports closed-loop operation, so the connected drive can track shaft movement during acceleration, steady running, and stopping. Its medium frame size and familiar mechanical interface make it suitable for modular multi-axis assemblies where compact mounting and predictable motor response are important.

Under static load, the motor can deliver a continuous stall torque of 24.0 Nm, allowing the drive to maintain force without exceeding thermal limits. At full speed, it reaches 4000 rpm, which supports short cycle times in machines that need quick indexing and rapid recovery between moves. A factory-installed brake provides 22 Nm of holding torque so vertical or suspended loads can remain secured when power is removed. Cabling exits on the right side through a sealed connector, which helps keep routing orderly in crowded installations. Power is transmitted through a plain shaft for coupling to gearboxes or belt pulleys.

For motion control, the motor uses digital servo feedback to send position data to the drive in real time. Mounting is centered by a 110 mm pilot diameter, and the housing follows the standard profile associated with length code D, which helps the unit fit established machine interfaces. The shaft end is fitted only on side A, leaving side B closed to reduce rear clearance requirements around nearby panels or guards. A shaft seal helps keep contaminants away from the front bearing in coolant-rich environments. The frame size 093 gives a practical balance between torque output and rotor inertia for mid-range automation axes.