Product Description:

The MDD093D-N-040-N2L-110GL0 is an AC synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts regulated electrical energy from Rexroth drive modules into controlled rotary motion for assembly lines, packaging stations, and other automated equipment. The permanent-magnet rotor and electronic commutation support precise speed and position control in closed-loop applications. This arrangement helps the motor respond quickly to command changes while maintaining smooth operation during repeated start-stop cycles.

Its continuous standstill torque is rated at 24.0 Nm, giving the axis holding force for positioning or vertical loads without overheating. Under rated excitation, the rotor can reach a nominal velocity of 4000 rpm, which supports short cycle times in indexing tables and other fast-moving stations. Position data are returned through digital servo feedback (DSF), so the drive can correct speed errors each control cycle and maintain accurate rotor alignment. Power and signal leads exit on the left side through a sealed connector, simplifying wiring in compact machine layouts. A centering shoulder of 110 mm aligns the flange on machine frames, and a shaft seal helps block coolant or dust from migrating along the plain shaft. The motor uses a standard housing with a connector interface, and motor length code D indicates the longest stack for this frame.

The rotor has Standard balancing quality, so attached couplings or pulleys can run without unusual vibration allowances. Because the motor is supplied without a blocking brake, the axis must rely on drive torque or an external clamp to hold position when power is removed. The motor size 093 frame gives the unit a compact profile for multi-axis gantries while preserving the mounting pattern used across this platform. The omitted B-side shaft end also keeps the output arrangement simple for direct coupling to driven equipment.