Product Description:

The MDD093D-N-040-N2L-110GB0 is a synchronous servo motor built by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. Intended for direct use with digital drive controllers, it translates commanded current into precise rotary motion for indexing tables, form-fill-seal machines, and general handling axes across automated production lines. Its synchronous design supports accurate speed and position control during repeated start-stop cycles. This makes it suitable for transfer equipment and packaging axes that require accurate stopping after rapid motion changes.

It delivers a continuous standstill torque of 24.0 Nm, allowing the axis to support load without overheating. Under rated excitation, the rotor reaches a nominal speed of 4000 rpm, giving high throughput for short-stroke moves. Position and speed are monitored through digital servo feedback (DSF), so the controller receives closed-loop motion data without separate external sensors. Mechanical centering during mounting is simplified by a diameter of 110 mm, while the rotor and housing use standard balancing to help limit vibration. Power and feedback leads exit on side B, leaving the opposite face clear for tight machine layouts. The motor uses the standard housing form, and size 093 with length code D provides a compact diameter with a longer active stack.

All power and feedback wiring terminate on a keyed connector, which keeps the connection orientation fixed and supports orderly cable routing. Output torque is delivered through a plain shaft, and the interface uses a shaft seal to help block oil migration from connected gear stages. The motor is built without a side B shaft end, which allows flush mounting against nearby machine surfaces or belt tensioners. The motor is supplied without a blocking brake, so the axis relies on external holding torque during power-off conditions.