MDD093D-N-030-N2M-110GR2 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
-
In-Stock, Ships 3-5 Days
The Bosch Rexroth Indramat MDD093D-N-030-N2M-110GR2 is part of the MDD Synchronous Motors series and is designed for use with digital drive controllers. This motor has a nominal speed of 3000 min⁻¹ and delivers a continuous torque at standstill of 24.0 Nm. It comes equipped with an integrated multiturn absolute encoder, digital servo feedback, and features a holding brake with 22 Nm torque.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD093D-N-030-N2M-110GR2 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. As a motor intended for digital drive controllers, it converts commanded current into proportional torque for closed-loop positioning and speed regulation in automated machinery such as pick-and-place stations, gantry axes, and conveyor sections. Its electromechanical design couples permanent-magnet excitation with three-phase stator windings, supplying the dynamic response required for mid-range production cells.
This unit delivers a continuous standstill torque of 24.0 Nm, allowing stable axis holding without overheating during static positioning tasks. Its rated speed of 3000 min⁻¹ marks the operating point at which the drive controller can supply nominal current without field weakening. Wiring exits through a Right-side connection, and the machine interface uses a Connector for quick swap-out during service. Standard rotor balancing keeps vibration within ISO limits, and the standard housing resists contamination typically found in processing cells. Within the 093 frame the D length code accommodates an extended stator stack, raising magnetic flux without increasing diameter. A factory-installed shaft seal isolates the interior against coolant or oil ingress, while the single A-side shaft end simplifies coupling alignment.
A blocking brake is fitted, able to apply 22 Nm of static torque to secure vertical loads when power is removed. Position and multiturn information are captured by an Integrated multiturn absolute encoder, and motion data is streamed to the controller via Digital servo feedback (DSF), allowing lossless synchronization across coordinated axes. The flange registers on a centering surface of 110 mm, giving repeatable concentricity when the motor is exchanged. Power is transmitted through a plain shaft that contains no keyway, reducing backlash in clamp-hub couplings. Together these features suit the motor for packaging gantries and transfer lines that demand quick cycles and accurate positioning without supplemental encoders.
Frequently Asked Questions about MDD093D-N-030-N2M-110GR2:
Q: What type of encoder is integrated into the MDD093D-N-030-N2M-110GR2 motor?
A: This model features an integrated multiturn absolute encoder for precise position feedback.
Q: What shaft configuration is included on the MDD093D-N-030-N2M-110GR2 motor?
A: A plain shaft design is provided with a shaft seal for enhanced protection against contaminants.
Q: What is the holding brake torque of the MDD093D-N-030-N2M-110GR2 motor?
A: The holding brake on this model delivers a torque of 22 Nm for secure load holding.
Q: What is the centering diameter of the MDD093D-N-030-N2M-110GR2 motor?
A: This motor has a centering diameter of 110 mm, aiding in precise alignment during installation.
Q: What is the continuous torque at standstill for the MDD093D-N-030-N2M-110GR2 motor?
A: The continuous torque at standstill for this model is rated at 24.0 Nm.
