Product Description:

The MDD093D-N-030-N2M-110GR1 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Intended for use with digital drive controllers, it converts commanded current into mechanical motion for precise positioning and velocity control in automated machinery. This operating principle supports closed-loop regulation on packaging lines, gantry axes, and general handling systems where repeatable response is required. That makes it suitable for applications that require accurate starts, stops, and speed changes across repeated machine cycles. The motor can also support synchronized axis motion where timing and repeatability are important.

This model delivers a continuous standstill torque of 24.0 Nm, which allows it to hold demanding loads at zero speed during controlled operation. For power-off holding, the blocking brake provides up to 11 Nm of static torque, helping prevent unwanted shaft movement when the axis is stopped. Motion feedback is supplied through digital servo feedback (DSF) together with an integrated multiturn absolute encoder, so rotor position remains available over multiple revolutions without a reference move after startup. A nominal operating speed of 3000 rpm gives the motor a practical balance between rotational speed and torque for mid-range servo axes. The motor uses frame length D, which provides a deeper stator stack for increased thermal mass and a larger active winding section.

The centering pilot measures 110 mm, which helps align the motor concentrically with mating flanges or gearbox input faces. Power and signal connections exit on the right side through a sealed connector, which can simplify cable routing when several axes are mounted side by side in a machine frame. The housing layout keeps the electrical interface consolidated at one side of the motor. The output uses a plain shaft and includes a shaft seal, so torque can be transferred through a suitable coupling while internal bearing areas remain protected from contamination. Internal balancing is standard, which helps the motor run smoothly throughout its rated speed range and supports stable operation in positioning applications.