Product Description:

The MDD093D-N-030-N2L-130PB0 is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It is a motor for digital drive controllers that supplies precise torque and speed control to automated machinery such as indexing tables, packaging stations, and material-handling axes. This arrangement lets the paired controller regulate acceleration, deceleration, and steady-state motion with repeatable response during cyclic machine operation. A standard cast-aluminum housing encloses the stator, and balance quality is ISO G 2.5 Standard to help limit vibration during high-speed cycles.

This unit delivers a continuous standstill torque of 24.0 Nm, allowing it to hold or slowly move loads without overheating. Its nominal operating speed is 3000 rpm, which suits drive controllers that modulate three-phase excitation across a broad working range. Position on the mounting face is guided by a centering diameter of 130 mm, which aligns the housing concentrically with gearboxes or couplings. All power and feedback lines exit on Side B, and a rugged circular connector carries the motor and feedback circuits while keeping cable routing away from the shaft side. The rear connection layout leaves the shaft side clear for pulleys, couplings, or other driven machine elements.

Closed-loop control is provided by digital servo feedback, giving the drive rotor position information for accurate velocity regulation and stable axis response. The steel output shaft uses a keyway for positive torque transfer, and the shaft end is supplied with a shaft seal to help keep contaminants away from the bearing chamber. The motor is supplied without a blocking brake, so any holding force at standstill must come from the drive or an external clamp. It has a single shaft end with no extension on the opposite face, which helps keep the overall length compact. The motor has size code 093 and length code D, which correspond to the stator stack used for the stated torque and a common 140 mm square flange pattern.