Product Description:

The MDD093D-N-030-N2L-130PA1 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it converts commanded electrical input into controlled rotary motion for positioning and speed-regulated axes in handling, packaging, and assembly equipment. Its synchronous design supports closed-loop operation, so the connected controller can correct speed changes under varying load. The motor is suited to applications that need repeatable acceleration, stable velocity control, and accurate stopping behavior over frequent operating cycles.

For continuous duty, the motor delivers 24.0 Nm of torque at standstill, allowing it to hold rated current at zero speed without overheating. During motion, it reaches a nominal speed of 3000 rpm, which suits medium-inertia axes and general automation tasks. A blocking brake is integrated and provides 11 Nm of holding torque, so vertically loaded mechanisms can remain stationary when supply power is removed. Position data returns to the drive through digital servo feedback (DSF), giving the controller the information needed for commutation and closed-loop regulation. Mechanical centering is based on a 130 mm pilot diameter, which helps maintain accurate alignment between the motor and the mounting surface.

Electrical power and feedback cables enter on Side A through a keyed connector, which helps route the harness away from rotating machine elements. A shaft seal helps limit contamination at the bearing area, and a keyway supports positive torque transmission to couplings or pulleys. The motor uses length code D, indicating a long stator stack within this housing size. A standard cast-iron housing encloses the winding package, and the single shaft end keeps the drive side ready for direct mechanical connection.