Product Description:

The Bosch Rexroth Indramat MDD093D-N-030-N2L-130GB1 belongs to the MDD Synchronous Motors series and is used with digital drive controllers in industrial automation. It converts commanded current from the drive into rotary motion, while the integrated encoder returns position data to the controller for closed-loop operation. With a standard housing, a plain shaft, and an integrated blocking brake, this model suits applications that require fast cyclic positioning without an external holding device. It is appropriate for automated axes that need repeatable motion and stable motor response during frequent start-and-stop cycles.

The motor develops 24.0 Nm of continuous torque at standstill, so it can hold or slowly index loads for long periods without overheating. Its nominal speed is 3000 rpm, which is the rated operating point for continuous use. When power is removed, the blocking brake supplies 11 Nm of static torque to help prevent axis drift in vertical or suspended setups. Position and velocity are reported through digital servo feedback, giving the controller the information needed for accurate closed-loop regulation. Power, feedback, and brake wiring exit on side B of the frame, which can simplify cable routing when nearby components are installed on the opposite side. This combination supports both controlled holding at low speed and consistent rotary motion during normal operation.

A centering diameter of 130 mm aligns the motor accurately in flange bores and helps maintain concentric mounting. Accurate centering also helps connected couplings and mounted components run with reduced misalignment. The single-ended power plug uses a connector interface, which allows direct connection of the mating cable. Motion is transmitted through a plain shaft, and a shaft seal helps keep lubricant away from the encoder chamber. The D-length stator section gives the motor a longer active package within this frame size.