Product Description:

The MDD093D-N-030-N2L-110PA2 synchronous motor is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it converts regulated drive output into rotary motion for axes that require accurate speed and torque control in automated machinery and assembly equipment. Its electromechanical design suits packaging lines, gantry systems, and tooling spindles where repeatable motion under closed-loop control is required. This arrangement allows the connected drive to respond smoothly to changing loads during indexing, positioning, and continuous-motion tasks.

It delivers a continuous standstill torque of 24.0 Nm, allowing the axis to hold static loads while energized without exceeding normal thermal limits. During operation, the rotor can reach a nominal speed of 3000 rpm, which fits common servo applications that need a broad operating range. The integrated blocking brake provides 22 Nm of holding torque, helping keep vertical or suspended mechanisms in place when power is removed. Position data is supplied through Digital servo feedback (DSF), which gives the controller high-resolution angle information for precise closed-loop performance. A centering diameter of 110 mm provides a precise pilot fit on mounting flanges, and the connections are located on Side A to simplify cable routing.

The shaft has a keyway, which provides a positive mechanical interface for pulleys or couplings, and a built-in shaft seal helps limit the ingress of dust and cutting fluids. Power and feedback lines terminate in a sealed connector, avoiding the need for open terminal-block wiring at the motor housing. The stator uses Motor Length Code D, which provides the thermal capacity needed to support rated torque during extended duty. Standard rotor balancing helps reduce residual vibration, and the motor uses a single shaft end to avoid additional overhang mass. The housing also keeps the motor compact enough for machine axes that need stable alignment and controlled rotary motion.