Product Description:

The MDD093D-N-030-N2L-110GL1 synchronous motor is produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It acts as a permanent-magnet AC servo element for digital drive controllers and supplies commanded rotary motion for positioning or velocity-controlled routines in automated assembly equipment, packaging lines, and material-handling axes. Its operating concept supports closed-loop motion, so the paired controller can regulate speed and position with stable response during repeated starts, stops, and indexing moves.

At its rated point, the motor delivers a continuous standstill torque of 24.0 Nm, which indicates the load it can hold at zero speed without thermal overload. During power-off conditions, an integrated blocking brake supplies 11 Nm of holding torque to secure vertical or suspended loads. Dynamic capability is supported by a nominal speed of 3000 rpm, which suits fast cycle operation on compatible inverters. Electrical power, feedback, and brake conductors are routed on the left side through a single connector, which keeps cable entry consolidated and helps reduce crowding around the housing. Digital servo feedback transmits position data to the controller, and standard rotor balancing helps limit vibration and bearing wear across the usable speed range.

The centering pilot is 110 mm in diameter, allowing accurate concentric mounting to gearheads or coupling flanges. Frame size 093 with length code D provides useful thermal mass while keeping the package compact for machine layouts with limited space. A plain shaft emerges on side A only, because the shaft end on side B is omitted to shorten the overall assembly. A shaft seal helps restrict contaminant ingress at the output side, and the standard housing further protects internal windings from dust and moisture. This single-sided shaft arrangement also leaves more clearance near the rear of the motor for adjacent components and cable bends.