Product Description:

The MDD093D-N-020-N2L-130PL0 is a synchronous AC servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed for digital drive controllers, it converts commanded current into torque for positioning and velocity control on automated machine axes. The motor uses a D-length stack in a standard housing, and its keyway shaft end allows direct coupling to gearsets or belt transmissions used in packaging lines, material-handling stations, and similar motion tasks. This layout suits applications that need repeatable motion during frequent starts, stops, and speed changes.

This motor delivers a continuous standstill torque of 24.0 Nm, enabling stable force output when the rotor is energized but held stationary. A nominal speed of 2000 rpm provides moderate rotational velocity suitable for equipment that prioritizes torque over higher shaft speed. The centering shoulder measures 130 mm, which helps maintain mounting alignment under load. Power and feedback conductors exit through a left-side connector, which can simplify cable routing when several motors are installed along a common manifold. Position data are returned through digital servo feedback (DSF), so the drive can close the velocity loop with high resolution and minimal latency. The electrical connection uses a sealed circular interface, which keeps the motor connection compact.

The motor is equipped with a shaft seal that helps protect the internal bearings from coolant spray and dust. It is supplied without a blocking brake, so holding force must be provided externally when the axis is at standstill. Frame size 093 keeps the mounting dimensions consistent with the matching motor platform. The rotor uses standard balancing to limit vibration as speed increases. The housing has a standard finish, and the installed feedback hardware is matched to the drive system used with this motor.