Product Description:

The MDD093D-N-015-N2M-130GL0 is manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts regulated current from the axis drive into commanded rotation for industrial positioning or velocity loops. A standard housing and standard dynamic balance make the unit suitable for direct flange mounting while keeping vibration within normal operating limits. This layout supports reliable use on automated gantries, tool changers, feed axes, and other motion systems that require stable servo response over repeated cycles.

A centering pilot of 130 mm aligns the flange precisely with the machine face and assists concentric load transfer. The connection hardware is located on the left side, and the power and feedback lines mate through a keyed connector, which simplifies cable routing. During static operation, the stator can deliver 24.0 Nm of continuous standstill torque, allowing the size 093 frame to hold loads without overheating. Command and feedback are exchanged through digital servo feedback, so the controller receives high-resolution rotor position data for current-vector control. The motor uses length code D, which provides a longer active stack than shorter versions and increases thermal surface area for sustained torque generation.

Under rated excitation, the rotor reaches 1500 rpm, a speed that suits low-noise linear axes and large gear ratios. Position verification is supplied by an integrated multi-turn absolute encoder, which eliminates external homing routines after power cycles. Mechanical output is provided by a plain shaft in a standard single-ended configuration, while a shaft seal protects the bearing cavity from splash ingress. The motor is supplied without a blocking brake, so any power-off holding force must be provided by external clamps or by the drive when energized. The housing uses standard sealing for routine plant environments.