Product Description:

The MDD093D-N-015-N2M-130GA2 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Intended for digital drive controllers, it converts electrical input into controlled rotary motion for positioning duties in automated machinery. A standard housing, an integrated blocking brake, and a plain shaft make the unit suitable for axis modules that need reliable load holding and straightforward mechanical coupling. This type of motor is commonly used where repeatable motion, stable speed control, and accurate positioning are required during continuous production cycles.

Its rated motion profile is anchored by a nominal speed of 1500 rpm, allowing drive electronics to synchronize axis movement with moderate gear ratios. When the rotor is locked, the stator can deliver a continuous standstill torque of 24.0 Nm, so the motor can support sustained static loads in pressing or clamping duties. The built-in brake applies 22 Nm of holding torque to secure vertical loads whenever the controller is disabled. Mechanical alignment is aided by a centering diameter of 130 mm, which matches common mounting flanges and promotes concentric installation. Power is transmitted through a plain shaft, which omits keyways and supports direct coupling with suitable clamping elements. The active length corresponds to length code D, giving the motor the winding volume needed for stable torque output in its frame size.

Closed-loop control is supported by digital servo feedback that communicates rotor position to the controller in real time. Within the feedback chain, a multiturn absolute encoder records shaft revolutions across power cycles, so the axis can retain position information without a reference run after shutdown. Both power and signal connectors are positioned on Side A, which can simplify cable routing where cabinet access is limited or where harnesses must be kept away from moving machine parts. Standard balancing, a fitted shaft seal, and the connector arrangement help support smooth operation, reduce the chance of contamination reaching internal parts, and keep installation practical in general-purpose factory automation.