Product Description:

The MDD093D-N-015-N2M-110PR1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it supplies commanded torque and velocity to automated axes that require repeatable positioning. Inside its standard housing, the rotor is dynamically balanced to a standard grade so vibration remains low during operation. A keyway shaft end and an internal blocking brake make the unit suitable for vertical or intermittent-load tooling in packaging, material transfer, and general assembly cells.

During continuous standstill, the motor can deliver 24.0 Nm of torque, and it sustains this output without exceeding thermal limits because heat is routed through the frame. When energized at rated voltage, it reaches a nominal speed of 1500 rpm, allowing direct coupling to low-speed conveyors or indexing tables. Installation is aided by a centering diameter of 110 mm, which aligns the motor flange with compatible gearboxes. Rotor position is provided by an integrated multiturn absolute encoder, and the motor uses digital servo feedback so the drive can maintain accurate commutation and motion control. Power and feedback are routed through a right-angle connector that keeps cable routing compact.

For holding force at power-off, the integrated brake supplies 11 Nm of static torque, which helps prevent drift on vertical axes. All electrical terminations exit on the right-side connection, which supports orderly cable routing where side access is preferred. The stator stack uses motor length code D, providing more active iron than shorter versions in frame size 093. A press-fit shaft seal keeps lubricant inside the bearing cavity and helps block coolant spray. The standard housing finish, connector interface, and single-ended shaft suit factory automation layouts that do not require a side-B extension.