Product Description:

The MDD093D-N-015-N2M-110PB2 is a synchronous servo motor manufactured by Bosch Rexroth Indramat and supplied within the MDD Synchronous Motors series. Designed for industrial automation, the unit converts commanded current from a drive controller into controlled shaft rotation so that machine axes can accelerate, decelerate, and hold position under feedback control. Its mechanical envelope and internal permanent-magnet rotor make it suitable for medium-inertia conveyor sections, pick-and-place heads, and forming equipment where repeatable motion is required. This motor type is commonly used in closed-loop motion systems where steady torque, accurate positioning, and responsive speed changes are needed during repeated operating cycles.

At standstill, the motor can deliver a continuous torque of 24.0 Nm, allowing it to support static loads without overheating. Under rated excitation, the rotor reaches a nominal speed of 1500 rpm, a figure that balances torque production with reduced mechanical wear in low-speed processes. A blocking brake supplies up to 22 Nm of holding torque, preventing back-driving when power is removed. Cabling exits on Side B of the housing, which simplifies routing in cabinets mounted to the opposite face of the machine. Alignment with adjoining gear stages is aided by a centering diameter of 110 mm, helping keep the motor accurately seated during installation and operation.

Position data is supplied by an integrated multi-turn absolute encoder, and the drive receives this data through the motor’s Digital servo feedback (DSF) channel to close the control loop without external transducers. Power and feedback conductors attach through a keyed connector, helping keep cable installation orderly and secure. There is a shaft seal at the output end, so lubricants from connected gearboxes are less likely to migrate into the motor housing. A standard dynamic balance grade limits vibration, and the keyed shaft profile transfers torque to couplings without slip.