Product Description:

The MDD093D-N-015-N2M-110GB1 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it supplies closed-loop motion control to positioning tables, handling modules, and similar automated axes where precise velocity and torque regulation are required. In operation, the motor converts commanded current into controlled rotary motion so the paired drive can correct speed and position errors during normal use. This makes the unit suitable for repeatable indexing, feed movements, and other servo-controlled tasks in automated equipment.

This model delivers a continuous standstill torque of 24.0 Nm, providing the steady force needed for low-speed holding or creep duties. A nominal speed of 1500 rpm gives its rated operating velocity under nominal load and voltage. For safety during power loss or emergency stops, it is fitted with a blocking brake that provides 11 Nm of holding torque. System smoothness is aided by standard balancing, which helps limit residual vibration in direct-coupled loads. Rotor position is measured by an integrated multi-turn absolute encoder, allowing the drive to retain absolute position information after power cycling without a homing routine.

The mounting flange includes a centering pilot of 110 mm for repeatable alignment to gearboxes or machine frames. Power and feedback cables exit on side B and are mated through a single connector, simplifying cabinet routing. A shaft seal protects the bearing set from coolant or dust ingress, and the housing is sealed in the standard configuration. The driveline side uses a plain shaft for clamp or shrink couplings, while the opposite end has no secondary shaft extension. The motor uses size 093 and length code D, and digital servo feedback is carried through the same connection interface. This arrangement keeps cabling concentrated at one end and leaves the output side clear for coupling hardware.