Product Description:

The MDD093D-N-015-N2L-130PR0 servo unit is a synchronous AC motor manufactured by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. It interfaces with digital drive controllers to convert electrical commands into controlled mechanical rotation for positioning, conveying, or forming axes in industrial automation cells. Its synchronous design supports precise speed regulation and repeatable axis response during closed-loop operation. This makes the motor suitable for applications that need steady torque delivery and accurate motion control across repeated production cycles under varying load conditions.

This model develops a continuous standstill torque of 24.0 Nm, which supports moderate static holding and low-speed process forces without overheating. Under rated excitation, it reaches a nominal speed of 1500 rpm, allowing gear ratios to be selected for slow but high-torque motion. The flange uses a centering diameter of 130 mm to keep the stator aligned with the machine interface and reduce mounting runout. Rotor position is supplied by built-in digital servo feedback, allowing the controller to monitor speed and position during operation. All power, feedback, and brake conductors leave through a single circular connector on the right side, which helps keep cable routing concentrated on one end of the housing.

The output shaft uses a shaft seal and a keyway, so torque can be transmitted securely while helping block contaminants from entering the bearing area. The housing follows length code D, which provides additional internal active length compared with shorter motors in the same frame. The motor is supplied without a blocking brake, so holding torque during power-off conditions must be provided by the drive or an external device. The rotor has no side-B shaft extension, and the closed rear end supports a standard single-shaft arrangement. Standard balancing and the rigid housing help limit vibration transfer to the driven machine.