Product Description:

The MDD093D-N-015-N2L-130PB0 is a synchronous motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed as a drive element for digital controller systems, this motor converts electrical power into precisely regulated mechanical motion so automated axes can hold position, follow velocity commands, or execute interpolated moves in material-handling and processing lines. Its synchronous operating principle supports stable torque production and repeatable motion response in applications that demand accurate positioning over changing load conditions. In servo-driven equipment, this behavior helps the motor follow commanded motion profiles while limiting deviation during acceleration, deceleration, and dwell.

At standstill the motor can deliver a continuous torque of 24.0 Nm, allowing the axis to hold demanding loads without auxiliary gearing and improving control authority at low speed. Once rotating, it reaches a nominal speed of 1500 rpm, which serves as the main operating point for drive tuning and steady-state thermal behavior. Mounting alignment is simplified by a centering diameter of 130 mm, which fits common flange patterns for this motor frame and helps keep the motor accurately seated on the machine face. Power and feedback leads exit on the side B of the housing, and the unit uses a pluggable connector so wiring can be disconnected without opening the motor housing. That cable arrangement can simplify routing where adjacent guards or tooling leave limited clearance around the non-drive end.

Position data are returned through digital servo feedback, enabling high-resolution closed-loop control without external encoders and supporting precise regulation of speed and position. The motor belongs to size 093, which helps match the unit to compatible mechanical interfaces within this frame family. A factory-installed shaft seal helps keep coolant and dust away from the front bearing, while the keyed shaft supports direct coupling to pulleys or pinions in enclosed machine assemblies. Because the unit is supplied without a blocking brake, any holding function must be provided by the drive or by external clamps. The standard housing fits the D-length envelope for this frame, and the single-ended shaft on the A-side reduces overhung mass for inline layouts that need only one mechanical output.