MDD093D-N-015-N2L-130PA2 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
5 Minutes
27 Seconds
The Bosch Rexroth Indramat MDD093D-N-015-N2L-130PA2 is part of the MDD Synchronous Motors series and is designed for use with digital drive controllers. This motor has a centering diameter of 130 mm, a nominal speed of 1500 min⁻¹, and provides a continuous torque at standstill of 24.0 Nm. It features a blocking brake with a holding brake torque of 22 Nm and digital servo feedback.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD093D-N-015-N2L-130PA2 is a synchronous servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Supplied as a motor for digital drive controllers, it converts commanded current into mechanical rotation for axes that require accurate speed and position in industrial automation cells, transfer lines, and packaging equipment. Standard housing, a balanced rotor, and a connector-based wiring interface support straightforward installation, while the built-in digital feedback channel links the motor directly to the matching drive for closed-loop control. This type of motor is commonly paired with servo amplifiers that continuously compare command values with actual rotor position during operation.
At standstill, the motor can sustain a continuous torque of 24.0 Nm, allowing heavy loads to remain stationary without thermal overload. During motion, its nominal operating point is 1500 rpm, a base speed that supports controlled positioning when paired with appropriate gearing. Mechanical centering is provided by a 130 mm locating diameter that aligns the stator with adjacent machine frames. Power, brake, and feedback connectors are oriented on Side A, so cable runs leave in one direction for orderly routing inside the machine. Position and velocity data are reported through digital servo feedback, allowing the controller to correct disturbances in real time without an external resolver. That connector arrangement is useful where cabinet space is limited and cable bending paths must stay organized.
An integrated blocking brake supplies 22 Nm of holding torque when the axis must remain in position after power is removed. The brake is intended for holding at rest rather than for stopping the axis during normal deceleration. The output shaft is ground with a keyway, allowing direct coupling to pulleys, pinions, or clutches without custom hubs. A shaft seal helps keep lubrication mist and coolant splash away from the bearing area during machine operation. The rotor-stator stack uses the D length code, which provides a longer active section than shorter versions and supports smooth low-speed running.
Frequently Asked Questions about MDD093D-N-015-N2L-130PA2:
Q: Does the MDD093D-N-015-N2L-130PA2 motor have a holding brake and what is its torque?
A: This model includes a blocking brake with a holding brake torque of 22 Nm.
Q: What type of shaft and shaft end does the MDD093D-N-015-N2L-130PA2 motor have?
A: The output shaft features a keyway configuration without a side B shaft end.
Q: What is the continuous standstill torque of the MDD093D-N-015-N2L-130PA2?
A: This motor provides a continuous torque of 24.0 Nm at standstill for stable operation.
Q: What type of motor feedback does the MDD093D-N-015-N2L-130PA2 use?
A: The MDD093D-N-015-N2L-130PA2 uses digital servo feedback (DSF) for motor position feedback.
Q: Where is the electrical connector located on the MDD093D-N-015-N2L-130PA2 and what type is it?
A: The electrical connection is on Side A and uses a connector for easy installation.
