Product Description:

The MDD093D-N-015-N2L-130GA2 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It is intended for direct coupling to digital drive controllers where precise torque and speed regulation are required in automated machinery. By combining electronic commutation with permanent-magnet excitation, the unit supplies closed-loop rotary motion for positioning tables, packaging axes, and similar factory tasks. Because the feedback device and commutation data are integrated into the motor package, the connected controller can regulate acceleration, deceleration, and standstill behavior with consistent repeatability.

This motor delivers a continuous standstill torque of 24.0 Nm, allowing sustained load holding without thermal overload. During operation, it reaches a nominal speed of 1500 rpm, which suits applications that favor steady control over very high rotational speed. Position feedback is handled through Digital servo feedback (DSF), which sends incremental data to the drive for accurate velocity and position control. Accurate mechanical alignment is supported by a centering diameter of 130 mm, and all power and signal connectors face Side A for straightforward cable routing. The motor also uses standard dynamic balancing, a rugged housing, and a plug-in connector interface that maintains shielding continuity.

For static holding or emergency stops, the blocking brake provides up to 22 Nm of holding torque and engages when power is removed. The output shaft is a plain shaft with an integral shaft seal, which helps limit lubricant escape and reduce particle ingress at the bearing journal. The motor has overall length code D and frame size 093, giving it a longer active section than shorter motors in the same frame. The shaft end on side B is omitted to reduce overhung mass, and the housing uses a standard finish for direct mounting to machine structures.