Product Description:

The MDD093D-N-015-N2L-110PA1 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for digital drive controllers, it converts commanded current into controlled torque and speed for automated axes in machining centers, packaging equipment, and general factory handling lines. When paired with a compatible drive, the motor supports closed-loop motion for applications that require coordinated positioning, stable speed control, and responsive correction under changing loads.

At stall, the rotor can deliver 24.0 Nm of continuous torque, providing strong holding capability when motion is stopped. Under rated excitation, the shaft reaches 1500 rpm, which suits direct coupling to lower-speed mechanical loads. A blocking brake is built in, and its static capacity of 11 Nm helps secure vertical or suspended loads during power loss. Feedback is supplied through Digital servo feedback (DSF), enabling the controller to monitor rotor position with single-turn resolution and maintain accurate command response. Power and feedback conductors exit on Side A, which can simplify cable routing when the motor is installed deep inside machinery or near fixed mounting surfaces.

The flange centers on a 110 mm pilot, allowing accurate alignment with machine interfaces and precision gearboxes. A sealed circular connector carries power, brake, and signal lines in one connection point, which helps keep the installation compact and orderly. Torque is transmitted through a keyway shaft, and the output journal is protected with a shaft seal to help retain lubricant and reduce contaminant entry. The extended stack length increases thermal mass, and the single-ended shaft layout leaves no extension on side B, which helps reduce the space needed around the motor body. This arrangement suits compact servo assemblies where cable access, shaft coupling, and mounting alignment must all fit within a limited envelope.