Product Description:

The MDD093D-N-015-N2L-110GL1 synchronous motor is produced by Bosch Rexroth Indramat and belongs to the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it supplies regulated rotary motion to axes that demand constant torque in enclosed machining centers and assembly stations. Its integrated blocking brake supports position holding on vertical axes, while the standard housing fits common machine mounting arrangements. This layout makes the motor suitable for installations where compact packaging and predictable axis response are required.

Under continuous stall conditions, the rotor can deliver 24.0 Nm without overheating, providing a stable torque reserve for static loads. During operation, the motor reaches a nominal speed of 1500 rpm, which suits gear ratios commonly used in low-noise production equipment. Accurate mechanical alignment is aided by a centering diameter of 110 mm, which helps locate the flange concentrically on the machine frame. Power and feedback cabling exit on the left side, reducing routing strain when the unit is mounted close to a right-hand cabinet wall. A removable connector interface allows the motor to be connected without permanent hardwiring, which helps simplify installation and service access.

For position holding after shutdown, the integrated brake applies 11 Nm to the shaft, helping prevent drift on vertical slides without external clamps. Motion feedback is provided by digital servo feedback (DSF), allowing the drive controller to monitor rotor position and speed with closed-loop accuracy. The rotor transmits torque through a plain shaft, which omits keyways to reduce localized stress at the shaft surface. Protection against lubricant ingress is maintained by a design with a shaft seal. The D frame length and the 093 frame size give the motor a larger active section than shorter versions in the same platform, which supports stable operation during repeated starts, stops, and load changes.