Product Description:

The Bosch Rexroth Indramat MDD093D-N-015-N2L-110GA1 is a synchronous servo motor in the MDD Synchronous Motors series. Designed for digital drive controllers, it converts electrical commands into controlled rotary motion for industrial automation axes that require precise torque regulation and feedback-based position control. Its standard housing, standard balancing, and plain shaft layout support machine tool and material-handling duties across medium-inertia drive trains. The synchronous design also helps the paired drive maintain stable speed response during repeated start-stop cycles.

At standstill, the motor can deliver 24.0 Nm of continuous torque, allowing it to hold or slowly index loads without overheating. Under rated excitation, it reaches a nominal speed of 1500 rpm, which suits slow-speed spindles or gear-reduced conveyors that favor high torque density. Mounting is guided by a centering diameter of 110 mm, which helps keep couplings and flanges aligned during installation. The motor uses frame size 093, so its mechanical dimensions match other motors of the same envelope in the series. Position and velocity loops are closed through Digital servo feedback (DSF), which sends high-resolution encoder data to the drive for accurate control. Length code D indicates a longer active stack for higher torque output, and the standard housing supports straightforward installation in enclosed machine spaces.

Connections exit on Side A through a keyed connector, which helps route cables in compact machine enclosures. A factory-installed blocking brake applies 11 Nm of holding torque when power is removed, which is useful for axes that must remain stationary at rest. A shaft seal at the flange helps protect the bearing set from cutting fluid or airborne particles. The plain shaft is supplied without a second shaft end on side B, and the motor's standard balancing supports operation with flexible couplings at typical industrial vibration levels.