Product Description:

The MDD093C-N-060-N2L-110GL0 is a synchronous servo motor built by Bosch Rexroth Indramat for the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts commanded current into controlled torque and speed for coordinated motion in industrial robots, pick-and-place modules, and packaging machinery. Closed-loop operation with the connected drive helps keep position error low, so the motor can perform repeatable indexing, acceleration, and stopping movements even when the axis is exposed to changing mechanical loads and varying duty cycles during automated production.

The motor seats on a centering spigot of 110 mm, which helps align the housing accurately with the driven machine frame during installation. All power and feedback terminations point to the left side, and a keyed electrical connector carries phase conductors, protective earth, and signal leads without hard wiring. Under rated conditions, the rotor reaches a nominal speed of 6000 rpm, which suits fast indexing and other high-cycle axis motions. Rotor position and velocity are reported through digital servo feedback, allowing the associated drive to correct deviations within each control loop interval. The standard housing resists airborne oil mist, and a shaft seal helps prevent coolant from entering at the mounting face.

The motor is supplied without a blocking brake, so holding torque must be provided by the drive or by an external clamp when the axis is at rest. Its length designation is C, giving the motor a longer stack that supports higher continuous torque than shorter versions in the same frame size. A hardened plain shaft transfers torque directly to couplings or belt pulleys, making it suitable for direct mechanical connection where keyed output is not required. Internal balancing is maintained to Standard balancing for smooth running across the full speed range.