Product Description:

The MDD093C-N-040-N2L-130PR0 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Classified for use with digital drive controllers, this unit converts commanded current into precise rotational motion for automated assembly, packaging, and material-handling axes. Its electromagnetic design supports rapid torque development, while the integrated encoder lets the drive maintain tight position and velocity control. It is intended for applications where repeatable motion and closed-loop regulation are required throughout long production runs.

The motor’s mechanical interface relies on a flange with a 130 mm locating diameter, ensuring coaxial alignment with gearboxes or machinery frames. Power, signal, and grounding conductors exit on the right side through a keyed connector, allowing straightforward cable routing when cable bundles must be directed away from moving machine parts. Under rated conditions, the rotor reaches a nominal speed of 4000 rpm, which suits high-cycle positioning tasks that require short move times and quick recovery between commands. Rotor position is returned to the controller by Digital servo feedback (DSF), enabling accurate electronic commutation and giving the drive the data it needs for stable low-speed control and consistent tracking.

The motor has size code 093 and length code C, which gives it a deeper stator stack without changing the mounting face. The shaft uses a keyway and is supplied with a shaft seal, which helps limit lubricant escape and the entry of particulates at the bearing seat during routine operation. Because the unit comes without a blocking brake, holding position after power removal requires drive torque or an external clamp on vertical or suspended loads. The housing uses standard balancing and a single-ended shaft arrangement, which helps the motor fit into tightly packed machine layouts and supports direct coupling to common driven components.