Product Description:

The MDD093C-N-040-N2L-130GL1 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it is intended to deliver precise rotary motion in automation axes where rapid positioning and velocity control are required. The model belongs to motor size 093 and uses a standard housing, giving it dimensions suited to medium-frame machinery. It is commonly used in servo-driven equipment that depends on repeatable motion under changing load conditions.

This unit reaches a nominal speed of 4000 rpm, allowing fast cycle times in packaging or handling equipment. A blocking brake integrated into the rear section supplies 11 Nm of static holding torque so vertical loads remain secure when power is removed. The centering shoulder measures 130 mm, which helps align the motor with rigid couplings and reduces shaft runout. Power and feedback cables exit on the left side, which can simplify routing in compact machine layouts. Position data is returned through digital servo feedback (DSF), enabling high-resolution closed-loop control without additional sensors. The rotor uses motor length code C, giving a longer active stack than shorter motors in the same frame size. A connector interface carries the phase conductors and encoder leads, keeping installation modular.

Mechanical stability is maintained through standard balancing, which keeps vibration within DIN limits at rated speed. Electrical terminations use a connector instead of a fixed cable, which supports modular installation. The output end uses a plain shaft for direct connection to clamping couplings, and the motor is fitted with a shaft seal to help block contaminants at the bearing area. The shaft end on side B is omitted, which reduces overall length when only one drive element is needed. A standard housing finish is intended for typical industrial environments, and the sealed shaft area helps limit lubricant loss during extended operation.