Product Description:

The MDD093C-N-040-N2L-130GB0 is a synchronous servo motor produced by Bosch Rexroth Indramat for use with digital drive controllers in the MDD Synchronous Motors series. As a rotary actuator, it converts controlled electrical energy into precise mechanical motion for positioning and speed regulation in packaging stations, pick-and-place axes, and transfer lines. The model uses the common dimensional and feedback format found across this motor family, which helps it fit established machine layouts and control schemes. This makes it suitable for automated equipment that requires repeatable motion and stable closed-loop operation over changing load conditions.

Mechanically, the motor mounts through a centering pilot of 130 mm, which aligns the housing concentrically inside motor plates and helps maintain accurate shaft alignment. Power and feedback leads exit on Side B, which can simplify routing when the surrounding machine structure favors that cable direction. A single circular Connector carries both power and signal conductors, so the housing remains compact and wiring stays straightforward. At its rated operating point, the rotor reaches 4000 rpm, giving the drive system a high nominal speed for responsive axis movement. The length designation code C indicates a longer stator stack than shorter variants in the same frame, which supports higher continuous torque without changing the flange geometry. This combination allows the motor to fit applications that need compact mounting with strong dynamic performance.

The motor is supplied without a blocking brake, so holding torque must come from the drive or from an external holding device when power is removed. Position data is provided through Digital servo feedback (DSF), which gives the controller high-resolution rotor information for accurate closed-loop regulation. Frame size 093 places the unit within a standardized outer diameter group used across the MDD series, supporting consistent installation dimensions. The drive end is equipped with a shaft seal, which helps protect internal bearings against dust and spray while limiting the migration of lubricant. These features make the motor well suited for production equipment where precise feedback, secure shaft sealing, and dependable servo response are all required.